1HP Pool Pump Motor & Centrifugal Pump Replacement Motor FIT Century UST1102 FIT Hayward Super Pump SP2607X10-56J Frame Threaded Shaft - 3450 RPM 115/230V Dual Voltage (1-Pack)
1HP Pool Pump Motor & Centrifugal Pump Replacement Motor FIT Century UST1102 FIT Hayward Super Pump SP2607X10-56J Frame Threaded Shaft - 3450 RPM 115/230V Dual Voltage (1-Pack)
Description
Technical Compatibility Matrix: Replacement For: Century UST1102, A.O. Smith UST1102, 56J Frame Motors FIT Hayward Models: Super Pump SP1600, SP2600 Series (SP2607X10) [Requirement]: 115/230V Single Phase Power Source Only. Physical Specifications: - Horsepower: 1.0 HP (Up-Rated) - RPM: 3450 Single Speed - Frame Type: 56J (Round Flange / C-Face) - Shaft Type: Threaded (1/2-20 UNC-2A) - Service Factor: 1.10 Operational Characteristics: This 1HP Pool Pump Motor addresses torque loss and electrical insulation breakdown in aging pump systems. The copper-wound architecture is tested for thermal endurance and promotes sustained water circulation geometry. Engineered for a direct-fit replacement to restore factory-standard pump flow rates in residential environments. Safe Installation Guidelines: Designed for direct mechanical integration with standard pool pump wet ends. [Caution]: Disconnect all power sources before wire termination. It is highly recommended to replace the mechanical shaft seal during motor swap to ensure fluid containment. Avoid the use of non-insulated tools during voltage configuration.
Item Details
Seller
Lots Of Auctions
Pickup Location
2832 Anode Lane
Dallas, TX, 75220
Quality
Estimated Retail Price
$188.08
Buyers Premium
15%
Inventory Number
1079689785
Found in
Additional Details from the Manufacturer
This item information is coming from the manufacturer. Some of the details may vary from the Nellis Auction listing. Please check the Quality Rating and Notes for information specific to this listing
brand
AUTOTOPdimensions
Package: 24.35 lbMore features
- FIT Century UST1102 (formerly A.O. Smith), FIT Hayward Super Pump SP2607X10 series. This 1HP replacement motor is specifically engineered for 56J frame configurations with a C-Face round flange. Please verify the pump housing requirements for a 1/2-20 UNC-2A threaded shaft to ensure precise mechanical integration with your existing impeller.
- Rated for 115/230V Dual Voltage operation with a 1.10 Service Factor (SF). This Centrifugal Pump Replacement Motor delivers 3450 RPM at 60Hz, drawing 15.0/7.5 Amps respectively. Features high-grade copper windings and a reinforced steel shaft tested for continuous duty cycle and thermal stability under standard operational loads.
- Engineered to address mechanical fatigue in pool circulation systems. The motor housing is treated for environmental exposure and high-humidity airflows. This unit maintains the required torque for optimal water movement, supporting consistent filtration cycles through the pump assembly without direct chemical contact with electrical components.
- Engineered to address mechanical fatigue in pool circulation systems. The motor housing is treated for environmental exposure and high-humidity airflows. This unit maintains the required torque for optimal water movement, supporting consistent filtration cycles through the pump assembly without direct chemical contact with electrical components.
- Engineered to address mechanical fatigue in pool circulation systems. The motor housing is treated for environmental exposure and high-humidity airflows. This unit maintains the required torque for optimal water movement, supporting consistent filtration cycles through the pump assembly without direct chemical contact with electrical components.
See the deals
Get in on the action, thousands of new items added daily. Bid and win!
Start bidding now