E-Simpo 1pc G24d 2-Pin Led Light Bulb 5W/4.7" PLC10W LED PL Horizontal 180D View Angle 2U Tube Plug in PL-C CFL Replacement Frosted Daylight 6000K (5W LED for PLC-10W, 4.7")

1pc G24d 2-Pin Led Light Bulb E-Simpo 5W/4.7" PLC10W LED PL Horizontal 180D View Angle 2U Tube Plug in PL-C CFL Replacement Frosted Daylight 6000K (5W LED for PLC-10W, 4.7") Specification Input Voltage: 110V 220V AC Power: 5W LED, Replace CFL PL-C 10W PLC Lamp; 7W LED, Replace CFL PL-C 13W Non-Dimmable CRI>82 Horizontal Plug-in Bulb, 180degree view angle Base: G24d 2-Pin, compatible for G24d-1, G24d-2, G24d-3 Brightness: 5W 600LM 7W 800LM; Color Temperature: Daylight 6000-6500K Application: 5W is used to Replace PL-C 10W 2U CFL, 7W is used to Replace PL-C 13W 2U CFL. which are widely used in Use in Recessed/Surface-mounted Downlights, Recessed Cans, Table/Desk Lamps, Portables, Pendant Lamps, Ceiling Fixtures, Wall Washers, Wall Sconces, Family Rooms, Living Rooms, Kitchens, Dining Rooms, and Porches. Note: Plug and play for inductive ballast fixture, but remove ballast required for electronic ballast. THE ELECTRONIC BALLAST IN YOUR FIXTURE MUST BE REMOVED OR BYPASSED FOR THESE ADAPTERS TO FUNCTION PROPERLY. CONSULT AN ELECTRICIAN IF YOU ARE UNSURE. DO NOT OPERATE A LED BULB WITH A BALLAST IN THE FIXTURE,Otherwise the LED Lamp witll get flicking, burnt, smell, damaged. How to bypass the ballast? 1. Turn Off the Power. 2. Find the Ballast. Usually it is embeded inside the ceiling fixture. Pls pull off the existing PL lamp, reflector. Leave wire in junction box. and find the ballast. 3. Normally, the Ballast has a black and white wire on the input side (AC input side, 100V -120V for North America). It also has two red and two blue output wires. To bypass this ballast, please cut all the Input and output wires, so total 6 wires cut. 4. Then, you can connect the two red wires to the black wire. 5. Next, connect the two blue wires to the white wire. now ballast is bypassed.