EZROAD 1204-410 48V 325A 5K-0 Motor Speed Controller Compatible with EZGO Club Car DS 1996-UP Golf Cart 101840201 Compatible with Curtis 1204-411 1204-412 Speed Control 5K-0? 1018402-01

Model: 1204-410, P1204-410 48V, 325A, 5K-0, Programmable Compatible with Club Car DS 1996-UP Golf Carts 1018402-01, 101840201 Compatible with EZGO Golf Carts Compatible with a wide variety of industrial electric vehicles Compatible with Curtis 1204-411, 1204-412, 1204-413, 1204-416, 1204-417, 1204-418, 1204X-4202 Note: This unit is pre-configured for 48V, 325A, 5K-0. To adapt it for other models, reprogramming via handheld programmer is required. br> Compatible with Altrax AXE-4834, AXE-4834P Model: 1204-410 Programmable DC Motor Controller Specification: Voltage: 48V Current: 325A Throttle Type: 5K-0 EZROAD Programmable 1204-410 electronic motor speed controllers are designed to provide smooth, silent, cost-effective control of motor speed and torque on a wide variety of industrial electric vehicles. Key features of the EZROAD 1204-410 controllers include: 1. Infinitely variable drive and brake control 2. Power MOSFET design provides high efficiency (for reduced motor and battery losses) and silent operation. 3. High pedal disable (HPD) function monitors throttle status during turn-on and prevents operation until throttle has been returned to neutral [optional feature]. 4. Thermal protection and compensation circuit provides both undertemperature and overtemperature cutback, as well as steady current limit throughout the entire operating range. 5. Under voltage cutback function protects against low battery voltage, including low voltage caused by external loads Pot fault circuit shuts off controller if pot wires open. 6. Simple installation with no adjustments required. 7. Tin-plated solid copper bus bars. 8. Push-on connectors for control wiring. Connections: This is an upgraded controller featuring a J4 connector, designed for status LED indication or programming interfaces. These controllers have five low-current connections: four 6.35 mm push-on terminals (J1, J2, J3, and J5), and one 4-pin connector (J4). J1: Keyswitch. J2: Wire 1 of 2-wire throttle; Pot High of 3-wire or ITS throttle. J3: Wire 2 of 2-wire throttle; Pot Wiper of 3-wire throttle; Pot Low of ITS thottle; or electronic throttle input. J4: 4-pin connector, an external Status LED or a programmer can be connected to J4. Note: When J4 is used for a Status LED, a jumper must be added between pins J4-1 and J4-4. J5: Reverse signal output / main contactor coil driver. This is an aftermarket part, not an original. It is compatible with your device and will function like the original. Looking for parts compatible with Curtis controllers? Our inventory includes a comprehensive range of compatible parts. Simply enter your model or part number to find the exact match in our store. Our product specialists are available for support.