Jumper Cable Clamps Compatible With Mil.waukee Compatible With M18 18V Battery Jumper Starter, 8AWG Automotive Booster Cable

Features

• Jumper Cable Clamps: The jump starter cable is designed to be compatible with Mil.waukee batteries. When your car battery drains and leaves you stranded, It may be difficult to find someone to help jump-start your car. Our jumper cables offer you a new solution, Only need to move the power adapter into the groove, Then push the converter and ensure it has locked the battery.
• Specifications: Wire: 8-AWG, The applicable range is 12-24v voltage. Perfect for most motorcycles, Cars, and SUVs, Capable of jumpstarting up to 5.0L gasoline and 3.0L diesel engines.
• Instructions: 1. Connect the red battery clip of the jumper cable to the positive pole (+) of the vehicle and the black to the negative pole (-); 2. Insert the battery into the adapter and ensure it is securely locked; 3. Start the car and disassemble the Lower clamp. Pay attention please NOT reverse the operation sequence of the jump starter
• Note: Check your device power before using, The battery charge should ideally be above 50%. 1. If the first ignition fails, wait a few minutes before attempting to ignite again. 2. If the ignition is successful, Remove the product from the vehicle within 30 seconds, or it may cause security incidents
• High Quality: Our adapter box is made of durable ABS plastic material. The adapter part is made of pure copper, Which greatly improves conductivity and safety. The cables are covered with fire-resistant silicone rubber insulation, and the clamps are made with fully insulated materials to prevent sparking. Disclaimer: This third-party accessory is designed to be Compatible with Mil.waukee tools and is not affiliated with the brand.