Upgraded 2.0 RPM Auger Motor, Fire Burn Pot and Hot Rod Ignitor, Grill Induction Fan for Traeger and Pit Boss Pellet Grill, Fire Pot Replacement for Traeger Parts Replacement, with Ash Remover, Screws

Features

• 🔥【Perfect Fits】- The Grill Replacement Parts for Traeger and most Pit-Boss pellet grills (NOT ALL Pit-Poss, EXCEPT PTG). 🔥【Not Fit】- Don't fit Traeger Tailgater 20 and Pit Boss 1150 grills
• 🔥【Dimensions】- Fire Burn Pot: 5" x 3 1/2" x 3 3/4", 7 Large air holes, 14 gauge steel wall. Total length of Hot Rod: 30". Hot stick: 3.7". High density cartridge heating element, 200W/120V wire lead, identical match to the OEM hot stick. Grill Induction Fan: 110V PA66, white nylon fan blade. Auger Motor: 2.0 RPM, 120V 60Hz 2 Pole
• 🔥【Material & Easy to Clean】The Fire Burn Pot with porcelain coated, it is more easy to clean the ash and the metal parts are fully covered with porcelain, provide effective protection from oxidation, the service life is longer than ordinary ones
• 🔥【Valuable Package】- Heavy duty grill replacment part includes: 1 auger motor, 1 induction fan, 1 fire burn pot, 1 hot rod ignitor and fuse, 1 set of screws. 🔥【Easy to Install】 - Plug and play wiring, took only about 10 minutes to replace. For better performance, only 1/8 inch to 1/4 inch of the wire should be visible in the fire burn pot
• 🔥【Installation Tips】- 1) Remove and save the screws from the old fire pot. 2) Rotate the fire pot 45 degrees so the corners point outward and are not parallel to the auger anymore. 3) Lift the outward flang (away from the auger) of the fire pot to pull the part up and out from the auger tube. 4) Replace in reverse order either using the new screws if they fit, tap threads into your existing grill to accept the new screws. If new screws can't work on your grill, please use your old screws